Once you have purchased an infrared panel, you can place it both horizontally and vertically. For vertical placement, you can use the standard brackets. But if you want to hang the infrared panel from the ceiling, you will need a hanging system. The existing brackets may not be sufficient or may be difficult to place against the ceiling.

Especially for the larger panels there were no suitable hanging systems on the market. In collaboration with some of our customers and the manufacturer, we have developed a special INFRARED HANGING SYSTEM.

The following customer wishes were taken into account:

• Height adjustability
• Optical appearance
• Installation time
• Minimum number of holes in the ceiling
• Broad applicability for different sizes.

Height adjustability: The infrared hanging system has 2 legs that can be screwed onto the bracket of the panel. Both legs are 35 cm. The main cable that runs to the ceiling is 1 meter. This main cable goes into a conical grip system allowing you to hang the panel at height in no time. For example, it can be set against the roof in the summer.

Optical appearance: Because the panel hangs against the ceiling, little is visible of the hanging system. Because the system consists of only a few cables, it is not obstructive in the room.

Installation time: Drill 2 holes, 2 plugs and screw tight, you won't need more than 10 minutes to adjust your panel as you like.

Minimum number of holes: The hanging system has 1 hole per 2 points on the panel. So few holes in your ceiling and still a sturdy suspension.

Wide applicability: If you have a panel of 60 cm, you only need 2 points. With a meter you can use 3 points and with 120, 4 points.

You can easily use these panels in homes and hobby rooms as well as in workplaces and offices, where there is no heating available.

If you want to hang your panel in a different way. So at an angle or at different heights, also look at the other adjustable solutions that Staalkabelstunter has. See all hanging systems here.